Hay budden anvil company9/2/2023 ![]() Perhaps this is just something only seen in old posts, but one poster consulting AIA to answer another posters question about an anvil they have had always seemed to me the same as stealing from Mr. The most obvious example I can think of off the top of my head is Anvils in America. The horn size was perfect for many projects. So I Googled Hay Budden catalog and found what is the same exact PDF someone saved here after putting the individual page scans into a single PDF on the Blacksmiths Association of Missouri site. The Hay Budden I used was 135 or so, had good rebound. You dont have to worry about face separation in the redressing process. They also made anvils for many large and also smaller hardware companies. In the past I have completely heated the face and reforged the corners and leveled the face and then re hardened the complete anvil with good results ending up with essentially a new anvil. Budden started making anvils on Front Street in Brooklyn in 1886. Anvil Blacksmith Forge In this video, I’ll show you some down and dirty techniques to get your barn-find anvil looking in ship shape in a hurry It’s not. You will find that unless the anvil is in truly horrible shape, youre better off using it as-is. I would do a lot of research before you go after the anvil with welding rod and ruin a usable anvil.Īny welding on that will ruin the heat treatment near the weld. It is way more complicated than what you are proposing but it can be done. ![]() I am considering buildup of the face to make it flat, but seing as how it is wrought iron should I weld on it My initial research indicates it can be welded with ordinary low carbon steel rod. It is usable as is with good ring and rebound but it is not flat at all. The face is depressed about 316 in the center 13 all the way across. We show how we clean up anvils, how we enhance their. ![]() Using the BOOKLET setting on my printer (and carefully following the instructions) I got a nice copy of your catalog. 218 8.7K views 2 years ago Today we restore a 1908 Hay Budden Blacksmith Anvil, Made in America and forged of a two piece construction. ![]() The images and PDF file appear to be hosted on IFI already.Īt just under 2lb, if the anvil is in good shape, you did very well. My anvil is a HB from 1914, so it is nice to see the catalog as well. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |